This is a high quality enclosure gasket/riser that fits the Lacroix Prototipo like a glove and gives a professional flawless looking appearance.

Most of the cost to make these is in the rubber itself. Neoprene is one of the hardest wearing rubbers and does not off-gas with nasty fumes like cheaper rubbers often do.

To install the gasket we recommend carefully gluing it to the enclosure so it stays aligned. Superglue (especially rapid curing types) makes the strongest bond with rubber, and can be applied in small sections. Another option is to use epoxy with lots of clamps such as office fold back clips, which is a much faster method but with higher risk of the gasket shifting during the long cure time.

• High quality neoprene rubber
  

• 8mm thickness

• Allows 2170 cells with LLT BMS to fit on top.

For electric skateboards and longboards, esk8 and eskate DIY.